reference current造句
例句与造句
- To be mentioned that the bandgap reference current source is vital for the op amps to improve its performance , and it did n ' t affect the circuits " power disspation too much
还值得一提的一点是，应用cmos工艺所设计的带隙参考电流源对电路性能的提高具有重要的作用。 - Each module is controlled by voltage - current two closed - loops . the common voltage loop controls system output voltage & frequency , and generates a common reference current signal
每台航空静止变流器模块均为电压、电流双环控制，通过公用电压调节器稳定并联系统的输出电压及频率，同时产生统一的模块电流给定信号。 - In this thesis , analysed and designed the architecture of the new type cmos rail - to - rail operational amplifiers in detail , and successfully designed one of two stage compact cmos rail - to - rail amplifier and the cmos bandgap reference current source
本次论文详尽地分析和研究了新型cmosrail - to - rail运算放大器的结构，完成了两级压缩式cmosrail - to - rail运算放大器和cmos带隙参考电流源电路的设计。 - Specifically analysed and presented the common - mode differential input stage , linear transconductance control circuit of input stage , current sum circuit , floating ab - class control output stage , the bias circuit of op amps and the bandgap reference current source circuit
具体对运放的共模差分输入级、输入级线性跨导控制电路、电流和电路、浮动ab类输出级电路、运放的偏置电路和带隙参考电流源电路进行分析设计。 - The dynamic model of asvg is established , which is regard as bases of transforming the reference currents to the reference voltage . principle of selecting main model parameters is discussed . based on the ip - iq method , the reference current signals are detected from load currents
本文建立了四桥臂asvg的动态模型，以此作为参考电流转化为参考电压的依据；讨论了模型主要参数的选取原则；确定了以ip - iq法作为参考电流的检测方法。 - It's difficult to find reference current in a sentence. 用reference current造句挺难的
- When the elastic design method is used , the paper proposes the recommendation that designer can not consider second - order effect on structural internal force , but must consider the effect on drift computing , and also gives a simplification method for calculating the second - order drift . base on above research achievements and referencing current design codes and research documents , this text has done overall discussions on the elastic design method , the chief works includin
基于前面的研究成果，参考现有各国钢结构设计规范和已有的研究文献，本文首次对钢结构错列析架体系的弹性设计方法作了全面的探讨，主要工作包括材料的选用、构件截面形式、构件弹性设计方法、连接节点设计和构造详图、组合楼盖的设计、栓钉剪力连接件的设计。 - In this circuit , reference current sources are used to charge and discharge capacitors . this oscillator ’ s output is very ideal through control circuit under 5 . 7v reference voltage , and oscillator ’ s frequency and duty - cycle could be adjusted if reference current source or capacitors in the circuit was adjusted . and the changes of temperature and voltage affect stabilize of the frequency little
此电路利用系统内部基准源产生的电流信号来对电容进行充放电,然后经过控制电路作用后,产生的输出振荡波形的上升时间和下降时间非常小,更接近理想矩形波形;通过调节基准源电流信号或者电容值大小,可调节振荡波形的频率和占空比,同时温度和电压的变化对振荡器输出波形频率稳定度的影响很小。 - According to the comparison of related reference , the circuit had lower power consumption in the same process . more pieces meaned more complicated , so through the ptat and ctat current achieved above , we could accomplishd the simplest multi - order compensation of temperature , and got the output voltage with low tempereature coefficient . it was reasonable to use the ptat and ctat current achieved above to get reference current with low temperature coefficient through reasonable design
与相关文献相比,在工艺相同的情况下具有更低的功耗。考虑到分段越多,电路会变得越复杂,利用得到的ptat电流和ctat电流完成温度的两段线性补偿,获得温度系数很小的基准电压输出。利用上面的ptat电流和ctat电流,合理设计电路获得较小温度系数的基准电流。